Automatic intermittent gear pump AMO-II-150S

Specifications Pump Discharge Volume 150ml/min (50Hz)　180ml/min (60Hz) Discharge Pressure 2.0MPa (safety valve set pressure) Motor Voltage / Current AC100Vφ1/0.83A　AC200Vφ1/0.41A (50Hz) AC100Vφ1/0.64A　AC200Vφ1/0.33A (60Hz) Output 20W (50Hz/60Hz)　CondesorMotor Emergency Detection Oil level pressure Oil level switch Contact Type　 A Contact (NO) ON at low level Contact capacity　 0.5A AC DC200V/30W smaller Prerssure switch Contact Type　 A Contact (NO) […]

Contact advice Download documents

Detail infor

Specifications

Pump

Discharge Volume

150ml/min (50Hz)　180ml/min (60Hz)

Discharge Pressure

2.0MPa (safety valve set pressure)

Motor

Voltage / Current

AC100Vφ1/0.83A　AC200Vφ1/0.41A (50Hz)
AC100Vφ1/0.64A　AC200Vφ1/0.33A (60Hz)

Output

20W (50Hz/60Hz)　CondesorMotor

Emergency Detection

Oil level pressure

Oil level switch

Contact Type	A Contact (NO) ON at low level
Contact capacity	0.5A AC DC200V/30W smaller

Prerssure switch

Contact Type	A Contact (NO) Operating pressure:1.7MPa　OFF Reset pressure: 0.9MPa　ON
Contact capacity	AC DC250V/3A

Operation Rating

Max. Discharge time:99sec
Min. Interval time:1min

Working Viscosity Range

68〜1000mm²/S (50Hz)

Reservoir Capacity

1.8ℓ、3ℓ (plastic)　3ℓ、4ℓ、8ℓ (sheet metal)

Weight

1.8ℓReservoir：3.3kg　3ℓReservoir：4kg(plastic)

How To Order

Model

Model	Part Number
AMO-II-150S-1	202067
AMO-II-150S-1-3	202069
AMO-II-150S-1-P	202071
AMO-II-150S-1-P-3	202073

Model	Part Number
AMO-II-150S-2	202068
AMO-II-150S-2-3	202070
AMO-II-150S-2-P	202072
AMO-II-150S-2-P-3	202074

Directions for use

●	This pump unit requires a separate control circuit to operate.
●	Do not remove the oil strainer to keep the pump clear of foreign matter.
●	Replace or clean the suction filter at least once a year. Click here to view the service list.
●	Oil viscosity varies with oil temperature. Be sure to use oil within the working viscosity range. Refer to the viscosity table.
●	Do not use any special additive-contained oil, water soluble oil and solvent.
●	Periodically check the oil in the reservoir for impurities. Replace it, if necessary, with fresh oil immediately. Be sure to clean the reservoir before oil change.
●	Make sure that proper voltage and pressure are proper.
●	Do not overtighten the discharge joint. Refer to the tightening torque table.
●	Low-oil viscosity versions are available. Contact us for information.
●	For system planning information, Contact us.

Document

Pump Drawing

Wiring digram

Dimensional Drawing

	Improper handling can result in a death or serious injury.

	Electrical shock may be received under certain conditions.。

	Be sure to ground.