Please refer to the case by clicking each installation place.
Troubles due to use of unspecified grease CASE.1
Troubles due to use of unspecified grease CASE.2
Troubles due to use of unspecified grease CASE.3
Troubles due to use of unspecified grease CASE.4
Breakage of toggle bush / toggle pin
Troubles due to use of unspecified grease CASE.5
Failure of mold closing due to tie bar friction
Troubles due to use of unspecified grease CASE.6
Troubles due to use of unspecified grease CASE.7
Even if non-genuine grease is used, trouble will not occur immediately because it takes a considerable amount of time to replace the grease in the lubrication system piping.
It takes 103 days for the grease to reach the end of the machine under the following lubrication system conditions.
Calculate the time required for grease to reach the end
Condition example
- Downtime: 8000 shots
- Molding cycle: 15 seconds
- Total discharge amount per time: 8.4 ml
- Main pipe PH-60 8m + Steel pipe φ6 5m
- Branch pipe φ4: 2m each